YOUR AD could be here...
Hard core Geocaching friends might find this display already sufficient enough to find a location.
Beside the Latitude and Longitude values the current speed and course will be displayed.
E.g. specify (in the options) a distance of 1000m, then GPSLogger II will give you a audio signal & your BlackBerry® Device will vibrate every km. So you get informed that you have completed the user specified distance. Of course the signal comes again after an additional km. So you have the signal at 1km, 2km, 3km... When you want the signal every mile then please enter 5280 ft.
Additionally to the time and distance you will see your current speed and the average speed of your current logging session.
Once the GPS signal provide course information the red "N" of the compass image will point into the north direction.
The arrow in the direction view points into the direction of a stored location. When you are currently logging and have not loaded a location, the direction view points you into the direction of your start location.
To reach the location you have to travel into the direction displayed on the device (when the device in pointing to the top you are travelling into the correct direction - when it points to the bottom you are departing from the location).
Beside the direction arrow information you will see at the bottom the distance to the location, the estimated time you need to reach this location (depending on your current speed) and the course in which you have to travel (redundant to the arrow).
Please note that this function is not a navigation replacement - you will be guided into the direction the location - GPSLogger II does not take natural barriers like rivers or canyons into account.
Additionally you can select in the GPSLogger II options your preferred night mode color – you have the choice between red, yellow, blue and green.
© 2010 emacberry.com